EVS MulticamLSM Version 9.00 - March 2008 User's Manual User Manual
Page 111
EVS
Multicam - User Manual
Version 9.00
EVS Broadcast Equipment SA – March 2008
102
11.3.9.4
H
OW TO
R
ESTRIPE THE
T
IME CODE OF THE
C
URRENT
C
LIP
To restripe the time code of the current clip, proceed as follows:
1.
Recall the clip by moving the cursor on the desired clip and pressing
ENTER, or by clicking on it with the stylus.
2.
Press ALT-T on the keyboard to call the SET TC function.
The Set Time Code screen is displayed (without TC Type field with
PAL – refer to note below):
3.
If you want to modify the LTC time code and date, type in the new
time code for the Short IN point and date of the clip in the Set TC
field below the LTC field.
4.
If you want to modify the user-defined time code and date, type in the
new time code for the Short IN point and date of the clip in the Set
TC field below the USER field.
5.
If you want to modify the primary TC for this clip, press the A or B
key which corresponds to the requested primary TC.
6.
Press F2 to select CAM or CLIP mode
• In CAM mode, only the time code of the camera angle loaded on
the primary channel will be changed.
• In CLIP mode, the time code of all camera angles of the clip will
be changed.
7.
Press ENTER to confirm or ESC to cancel.
The entire clip is updated according to the new time code value so that the
time code remains continuous inside the whole clip.
Note
In 59.94Hz modes (NTSC), you can also select between DROP
FRAME and NON DROP FRAME modes by pressing the space bar.