EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 186)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
177
18.2 OVERVIEW ON COMMANDS
18.2.1 M
AIN
M
ENU
The Hypermotion menu includes the following main and a secondary menu.
The main menu displays the blocks that have been selected in the #Blocks
parameter of the secondary menu. Only the activated blocks will be displayed. The
block highlighted is the one the operator is currently working on.
18.2.2 S
ECONDARY
M
ENU
Pressing the MENU key opens the secondary menu:
# Blocks Pre-Roll PGMSpeed 2ndLever
2 00s10fr 50% +- 1000
The secondary menu gives access to the hypermotion settings described in the
table below. To modify a setting, press the corresponding softkey and jog to select
the requested value.
Setting Description Values
#Blocks Number of memory blocks of the hypermotion
camera to be used.
The number of blocks displayed in the main
menu depends on the number of blocks
specified in this parameter.
1 to 4
(default: 1)
Pre-Roll Pre-roll for the cue points defined on the
material recorded on the hypermotion camera.
The last cue command will go to the desired
TC - pre-roll if the material is available. If
not, the pre-roll is not applied.
From 0s01fr to
05s00fr
(default: 00s00fr)
PGMSpeed PGM speed that is to be applied for playing
back material recorded on the hypermotion
camera. 50, 100 (default),
200, 300, 400,
1000
Hyper Motion Camera Mode
# Blocks Pre-Roll PGMSpeed 2ndLever
2 00s10fr 50% +- 1000
LSM Mode
Block 1 Block 2