EVS XSnano Version 11.02 - July 2012 Configuration Manual - Manual (Page 37)

Overview on the Raid Configuration Window
The Raid Configuration window is available from the Multicam Setup window, when
pressing R to call the Raid Configuration command in the Tools menu:
The Requested Configuration area, in the upper part of the window, displays the default
raid configuration. You can modify the default raid configuration in this area. You will find
more information on editable parameters below.
The Current Configuration area, in the lower part of the Raid Configuration window,
provides raid and disk status information.
Default Raid Configuration
At the first start, the software builds the raids using the following settings:
• If internal and external storage are detected, both are used.
• (5+1) raid configuration with a maximum of 5 spares is used. First, all the raids are
built. The remaining disks are used as spare disks. The construction of raids starts
with internal arrays and carries on with external arrays. A raid can be created across
several hardware arrays.
Requested Raid Configuration
Overview
In the Requested Raid Configuration, you can modify the following parameters in the
default raid configuration:
• Use of internal and/or external storage.
• Use of spare disks.
• Number of raids to be used.
To modify one of these parameters, press TAB to select the requested field, and
SPACE BAR to select the requested value, or type the requested value.
CONFIGURATION MANUAL XSnano Server 11.02
2. Multicam Setup 29