High Lifter Lift Kit for Ranger IRS - Signature Series 3 - Manual (Page 6)

6
5) Next, insert the bottom of the shock into the top of the bracket. Place one of the 10mm flat washers
inside of the bracket on one side of the shock. Insert the 10mm x 70mm hex bolt through the bracket,
washer, and then shock.
(SEE NOTES ADDITIONAL NOTES FOR 800 RANGER INSTALLATION)
6) Connect the left bracket to the shock mount placing a 10mm washer between the shock and the
bracket.
7) Secure the brackets using two 10m lock nuts.
8) Repeat steps for opposite side.
9) Lower the jack and place the wheels back on the ATV.