High Lifter Lift Kit for Ranger IRS - Signature Series 3 - Manual (Page 8)

8
High Lifter Name Plate Installation
1. You will need to disassemble the tail gate. Remove the top rail and latch. Remove the screws that are on the side of
the tail gate that is to the inside of the bed.
2. Disassemble the tail gate and take the cover and place it on a flat surface.
3. Using the name plate as a guide, place it on the location shown in the photo. Center it and mark the ¼” bolt hole
locations.
4. Once you have market the ¼” holes, use a 1/” drill bit and drill the holes.