High Lifter Lift Kit for Polaris 550 - Signature Series - Manual (Page 5)

Rear Lift
1) Place jack under the center of the ATV, just forward of where the rear drive shaft connects to the
engine, and lift until the weight is off the suspension. Be careful to secure the ATV properly so it is
stable on the jack.
2) Remove the rear wheels.
3) Remove the lower control arms from both sides of the ATV.
NOTE: Starting with 2010 Models you must now remove the top A-arm and clearance the area
nearest the axle.
4) Remove the rear top a-arms.
5) Using a grinder trim the area nearest the axle.
6) Reattach the a-arms. (This photo shows the clearance)