MAXWELL MW-3017 BK - Manual (Page 5)

ENGLISH
5
When the sole temperature (14) reaches the
•
desired temperature value, the (10) indica-
tor will go out, you can start ironing
.
Note:
- While steam ironing set the necessary
intensity of steam generation using the steam
supply control
(5).
WATER SPRAYER
You can dampen the fabric by pressing the
•
spray button (3) several times.
Make sure that there is enough water in the
•
water tank (12).
Dry Ironing
Place the iron vertically.
•
Insert the plug into the socket.
•
Turn the temperature control (9) to set the
•
required ironing temperature: “•”, “••”,
“•••” or MAX,
( depending on the type of
fabric ), set the constant steam supply con-
trol to the “off” position, the (10) indicator
will light up .
When the sole temperature reaches the de-
•
sired temperature value, the (10) indicator
will go out, you can start ironing
.
After you finish ironing set the control to the
•
“MIN” position.
Pull the plug out of the socket and let the
•
iron cool down completely.
Steam ironing
Place the iron on its base (8).
•
Insert the plug into the socket.
•
Make sure that there is enough water in the
•
water tank.
Turn the temperature control (9) to set the
•
required ironing temperature: in the steam
operation zone or “MAX” (•••), the indica-
tor (10) will light up.
When the sole temperature reaches the de-
•
sired temperature value, the (10) indicator
will go out, you can start ironing
.
Use the constant steam supply control (5)
•
set the required intensity of the vapor gen-
eration, steam will start going out of the
openings of the iron sole (14).
After usage of the iron set temperature con-
•
trol (9) to the “MIN” position, and the con-
stant steam supply control (5) to the “off”
position (steam supply is off).
Pull the plug out of the socket and let the
•
iron cool down completely .
ATTENTION!
If during the operation steam is not constantly
supplied, check whether the steam supply
control (5) is set properly and whether there is
water in the water tank.
Additional steam supply
Additional steam supply function is useful while
ironing folds and can be used only at high tem-
perature mode (temperature control (9) be-
tween “••”, “•••”and “MAX”).
When pressing the steam supply button (4)
steam will go out from the sole.
Note:
- In order to avoid leakage of water from
steam openings, press the additional steam
supply button (4) with a 4-5 sec. interval.
Vertical steaming
Vertical steaming function can be used only
when the high temperature mode is used (set
the temperature control
(9) between «••» and
(MAX)).
Hold the iron vertically at the distance 15-30
cm from the clothes press the additional steam
release button (4) with a 4-5 seconds interval,
steam will be released from the sole (14).
Important information
Vertical steaming is not recommended for
•
synthetic fabrics.
To avoid melting the fabric, do not touch the
•
iron sole to the item while steaming.
Never steam iron clothing on a person as
•
the steam temperature is very high and it
can cause burns. Use a coat-hanger or a
stand.
Steam chamber cleaning
To prolong lifetime of the iron we recommend
cleaning the steam chamber, especially in the
regions with “hard” water.
MW-3017_INSTR.indd 5 MW-3017_INSTR.indd 5 29.06.2011 9:46:00 29.06.2011 9:46:00