Hotchkis 20104 Chassis, Max Brace, 10-13 Camaro - Manual (Page 3)

2010 Chevy Camaro
Hotchkis Performance LLC.
3
3. Now bolt the rear bracket onto the rear subframe using the holes that are
already existing. Place the provided spacers between the frame and the
brace as shown. Install the 12mm bolt from the bottom up and make sure to
use the small washers on the head and nut ends.
4. The Front bracket should now line up with its hole. Use the provided hex bolt
and LARGE washer on that bracket.
NOTE: Remember, do not tighten any bolts yet. Only start each bolt.
5. Now install the other side following the previous instructions.
SPACER
EXISTING HOLES