Hotchkis 80002 TVS System, Sport, 64-66, GM A-Body, Small Block User Manual
Page 34
64-72 A/Body, 78-88 A/G Body
Front Bar Installation
1.
Look carefully at the current installation.
2.
This installation can be performed without removing the front wheels.
Always use proper safety devices such as jack stands or lift jacks to
properly support the vehicle.
3.
Loosen front bushing retaining bolts, leave a few threads engaged to
support the bar.
4.
Remove the factory end link from the car.
5.
Support or hold the center of bar and carefully remove front bushing bolts.
6.
Remove factory bar from vehicle, taking note of the placement of the
swaybar bushings.
7.
Using the included white silicone grease, grease the inside of the urethane
1 3/8” in sway bar bushings. (The silicone grease can be cleaned up with
WD40.)
8.
Install the urethane bushings on
the bar. Make sure you position
the bushing so when the bar is
installed in the vehicle, the split
will face the front of the car.
9.
Place the bushing’s bracket over
top the bushing.