Naxa NPB-245 - Manual (Page 6)

5
USING THE CD
LOADING A DISC
1. Set the FUNCTION switch to CD/AUX position.
2. Open the CD door.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door.
The total number of tracks will appear on the display after several seconds.
5. To remove the CD, press OPEN to open CD compartment lid, grasp the CD by its edges,
and carefully take it out.
Note:
y To ensure good system performance; wait until the disc tray completely reads the disc
before proceeding.
y If no disc is loaded into the compartment, or the disc is placed upside down, the display will
show 00.
PLAYING A DISC
1. Press the PLAY/PAUSE button to start playback.
The playback starts from track 1, the PLAY/PAUSE indicator on the right lower corner of the
display illuminates.
To interrupt playback, press the PLAY/PAUSE button. The PLAY/PAUSE indicator flashes on
and off.
To resume playback, press the PLAY/PAUSE button again, the PLAY/PAUSE indicator
becomes steady on the display.
2. To stop playback, press the STOP button, the total number of tracks appears on the display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
y Press the CD SKIP/SEARCH FORWARD/BACKWARD button repeatedly in stop mode or
during play until the desired track appears on the display.
y Press the PLAY/PAUSE button to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the CD SKIP/SEARCH FORWARD/BACKWARD button to scan the current
playing track at high speed until desired point passage, then release the button.
Playback will start again from this point.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to 20 tracks can be
stored in the memory in any order.
1. In stop mode, press the PROGRAM button, the
01 will flash and the PROGRAM indicator
will be on.
2. Press the CD SKIP/SEARCH FORWARD button to select the first desired track to be
programmed.
3. Press the PROGRAM button to enter. The display changes to show 02 flashing.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5. Press the PLAY/PAUSE button to start playback from the first programmed track.
6. Press the STOP button to stop program playback.
Note: Program function can only be done in stop mode.