Naxa NPB-245 - Manual (Page 7)

6
To Erase the Memory (Program)
To clear the program, you have two options:
1. Press the STOP button when the disc is stopped, or
2. Open the CD compartment lid, program will be erased.
REPEAT
You can play one track or all tracks on the disc repeatedly.
To Repeat a Single Track
1. Press the REPEAT button once during play, the CD REPEAT indicator will flash on and off.
The current track will be played over and over again till you press the STOP button.
2. To cancel repeat play, press the REPEAT button twice. the CD REPEAT indicator turns off.
To repeat all Tracks
1. Press the REPEAT button twice during play, the CD REPEAT indicator becomes steady on, all
tracks on the disc will be played over and over again till you press the STOP button.
2. To cancel repeat play, press the REPEAT button once, the CD REPEAT indicator turns off.
Note: Repeat function also can be done in stop mode.
SPECIFICATIONS
CD SECTION
Channels: 2 channels
Optical pick-up: 3 beams laser
Frequency Response: 100Hz - 16KHz
RADIO SECTION
Receiving Band: AM/FM
Tuning Range: AM: 530 - 1600 KHz
FM: 88 - 108 MHz
Antenna: FM rod antenna, AM built-in ferrite bar
GENERAL
Output Power: 1.2 W x 2 (RMS)
AUX IN Jack: 3.5mm
Power Source: AC 127V ~ 60Hz
DC 9V 1.5V UM-2/C x 6pcs
Power Consumption: 13.5W
Note: Specifications are subject to change for continuous improvement without prior notice.
ESD Remark:
In case of malfunction due to electrostatic discharge, just reset the product (reconnect of power
source may be required) to resume normal operation.