Shogun Motorsports Suzuki GSX1300R (99-07) Frame Slider - Manual (Page 3)

7.
We put a bolt though the puck and lightly threaded into the bike. A pencil was then used to
draw our diameter of desired shaped hole. A flexible hole template can also be used for the
same purpose. Place the hole template on center of the pilot hole (or spot tool) and draw your
desired diameter.
8.
For this application we used a dremel tool with a sanding roll to open up the hole little by little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES As you cut and open the hole to
your scribe marks keep checking that the hole is lining up with your puck dimensions or the spot
tool. If for some reason you cut too big and you want to close the gap around the puck we use
windscreen trim or window seal with 3m adhesive. Trim the seal to fit the hole and get the seam
to meet under the puck so it is less visible.
9.
Remove right side bolt. Mount right side puck with (99-HB-SH10125100) Socket Cap 10 X 1.25 X
100 Main Engine Stud and torque down.
10.
Remove left side bolt. Mount left side puck with (99-HB-SH10125090) Socket Cap 10 X 1.25 X
90 Main Engine Stud and torque down.