Spicer Tandem Drive Axles Service Manual S400 - Manual (Page 13)

INTER-AXLE DIFFERENTIAL DISASSEMBLY
NOTE: Use of a torque multiplier is recommended as
torque specification on input flanged hex nut is 900-
1,200 Lb-Ft (1,220-1,627 N-m). (Refer to RECOM-
MENDED SERVICE TOOLS, pgs. 29-30)
6. Remove input yoke using a suitable puller.
See Figure 5.
8. Remove input oil seal
9. Press out input shaft bearing cup from bearing
retainer. Retain shims for possible use during
reassembly. Early models were not a press fit.
10. Remove input shaft assembly. Remove input yoke
spacer from input shaft.
11. Remove front bearing cone from input shaft using
suitable puller.
12. Remove clutch collar, shift fork, and spring from
assembly.
13. Remove needle thrust bearing assembly from top of
drive gear.
14. Remove drive gear from inter-axle differential case.
15. Remove two lube retainer bolts.
16. Remove lube retainer.
17. Remove inter-axle differential assembly from case.
18. Remove rear Diff-gear from inter-axle differential
case.
19. Remove rear bearing cup from intermediate case.
20. Remove bearing cone from rear differential gearus-
ing a suitable puller.
21. Clean and inspect all components for excessive
wear, scoring, or cracks. Replace damaged compo-
nents with original equipment replacement parts
and prepare for reassembly.
Inter-Axle Differential Disassembly Complete
7. Remove bolts from input shaft bearing retainer. Use
removal slots
(See Figure 6) to seperate bearing
retainer from inter-axle differential case, and remove
retainer.
Removal slot
Removal slot
FFFFFigur igur igur igur igure 5 e 5 e 5 e 5 e 5
Yoke
Remover
FFFFFigur igur igur igur igure 6 e 6 e 6 e 6 e 6
11