Spicer Tandem Drive Axles Service Manual S400 - Manual (Page 14)

OUTPUT SHAFT DISASSEMBLY
End Yoke
Output Oil Seal
Beveled Retaining Ring
Output Shaft Bearing
Output Shaft
Housing
Flanged Hex Nut
(900-1,200 Lb-Ft)
(1,220-1,627 N-m)
1. Remove the inter-axle drive shaft.
NOTE: Power divider must be engaged so shaft will
not rotate.
2. Remove output flanged hex nut.
NOTE: Use of torque multiplier is recommended as
torque specification on output nut is 900-1,200 Lb-
Ft (1,220-1,627 N-m).
3. Remove output yoke using a suitable puller.
4. Remove oil seal.
5. Remove beveled retaining ring. 6. Place output shaft remover adapter into housing
bore.
7. Thread yoke installer service tool onto output shaft.
See Figure 7.
8. Tighten nut on yoke installer to pull output shaft
bearing assembly out of housing.
9. If output shaft bearing is to be replaced, remove old
bearing using a suitable puller or press.
NOTE: It is important to place the Output Shaft
Remover Adapter on with the shoulder to the outside.
See Figure 7.
Output Shaft Removal Complete
Housing
FFFFFigur igur igur igur igure 7 e 7 e 7 e 7 e 7
12
Yoke Installer
Service Tool
# DST1007
Output Shaft
Remover Adapter
w/Shoulder Facing Out
Output Shaft
Bearing Assembly