Spicer Driveline Components Catalog: Tubing and Tube & Tube Yoke Assemblies - Manual (Page 4)

Important: See Safety Information in General Information Section (J300P-GI)
4
ALUMINUM TUBING
Swaged Both Ends
J300P-6
*
NOTE: The part numbering system includes tube length in the last set of numbers, with the last two
digits as the number of 1/32 of an inch. Part numberings ending with “M” are measured in millimeters.
Example: -6025 is a 60 25 /
32
” long tube, -1862M is a 1862mm long tube
* Tubing size 3.9800 x .0750 uses the same aluminum tube yoke as 4.000 x .083 wall tubing.
Tubing size 5.0200 x .0750 uses the same aluminum tube yoke as 5.000 x .065 wall tubing.
Tubing size 5.0600 x .0920 uses the same aluminum tube yoke as 5.000 x .065 wall tubing.
B
Wall
Thickness
S=Seamless
W=Welded
D=D.O.M.-Drawn
Over Mandrel
Inside Diameter
(Nominal)
Part
Number
4.1600 Outside Diameter E=5.0200
.0860 S 3.9830 212014X-5809
Has foam deadner
.0860 S 3.9830 212014X-5903
Has foam deadner
.0860 S 3.9830 212024X-5929
Has foam deadner
.0860 S 3.9830 212014X-6015
Has foam deadner
.0860 S 3.9830 212014X-6025
Has foam deadner
5.0600 Outside Diameter E=5.7750*
.0920 S 4.8730 212218X-6924
Has foam deadner
.0920 S 4.8730 212218X-6820
Has foam deadner
.0920 S 4.8730 212218X-1862M
1862mm tube length; Has foam deadner
.0920 S 4.8730 212218X-1771M
1771mm tube length; Has foam deadner