Spicer Drive Axles Service Manual G & M - Manual (Page 28)

EXPORT IMPROVEMENT FOR M230-T MODEL
3. Apply a thin layer of Loctite #277 on the
threads of the ring gear bolts and install as shown
in
Figure 16.
RING GEAR BOLT RETAINER INSTALLATION
1. Follow Ring Gear and Support Case Assembly
procedures 1 thru 8.
2. Insert ring gear bolts through ring gear bolt
retainers.
See Figure 15.
4. Torque the ring gear bolts to 160-180 Lb-Ft (217-
244 N-m).
5. Bend tabs on retainers over flats of bolts. See
Figure 17.
CAUTION: If tabs on retainers do not align with flats on
bolts, tighten bolts to next flat that will align with tab.
NOTE: Continue assembly with Differential Support
Case Installation procedures outlined on Pg. 20.
FFFFFigur igur igur igur igure 1 e 1 e 1 e 1 e 17 7 7 7 7
Bent Tab
Ring Gear and Support Case Assembly Complete
FFFFFigur igur igur igur igure 1 e 1 e 1 e 1 e 16 6 6 6 6
Tabs
FFFFFigur igur igur igur igure 1 e 1 e 1 e 1 e 15 5 5 5 5
Ring Gear Bolt Retainer
26