Spicer New Installation Procedure for the Shift Fork Seal and Spring Assembly - Manual (Page 3)

0
Shift Fork
Shaft Bore
1/8"
052-9
Boot Face Should
be 1/8" off
Shift Fork
Shaft Bore
Shift Fork
Shaft Bore
Figure 3 Figure 4
Figure 3 - Install seal on shift fork over mounting studs.
Figure 4 - Seal should be installed down over the shift fork until the boot surface is approximately 1/8” from the
fork shaft bore.
052 SIDESTRC-SH
Figure 5 Figure 6
Figure 5 - Operate shift fork by hand through the entire working range, checking for stretching of the seal.
Figure 6 - A seal that has been stretched during installation has been installed incorrectly. Re-check steps 4
and 5 of the seal installation procedure.
Printing on Seal is Face
Down and Not Visible
Figure 7
Figure 7 - The seal & spring assembly is correctly installed on shift fork.
Stretched Seal-
Repeat steps 4 & 5