RUSSELL HOBBS 15129-56 - Manual (Page 4)

4
C REDUCING TEMPERATURE
23 Reducing temperature takes longer, as the appliance has to lose heat.
24 Organise your ironing so you don’t need to reduce the temperature (“preparation” point 2).
h STEAM IRONING
25 If you intend to use steam, the temperature setting must be S or higher.
26 If you don’t, you’ll get water on your clothes, not steam.
27 Set the steam control, to the setting you want (S = no steam,
# = high).
28 Wait till the light goes off, then start ironing.
k SPRAY
, Water spotting affects some fabrics. Test this on a hidden part of the fabric.
29 This function works with dry or steam ironing, as long as there is water in the reservoir.
30 Lift the iron off the fabric.
31 Aim the spray nozzle at the fabric.
32 Press the
* button.
33 You may have to press it 2 or 3 times to pump water through the system.
i SHOT OF STEAM
34 This function works with dry or steam ironing, as long as there is water in the reservoir.
35 If you intend to use steam, the temperature setting must be
S or higher.
36 Lift the iron off the fabric.
37 Press the
~ button.
38 You may have to press it 2 or 3 times to pump water through the system.
39 Leave 4 seconds between shots, to let the steam build up.
n DRY IRONING
, If you’re going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
40 Set the steam control to S.
41 Wait till the light goes off, then start ironing.
l VERTICAL STEAMING
42 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
43 Check that there is adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
44 Check that there is nothing behind the fabric that may be damaged by the steam.
45 Check that pockets, turn-ups, and cuffs are empty.
46 Check that there is water in the reservoir.
47 Set the temperature control to max. Set the steam control to S.
48 Lift the iron off the fabric.
49 Press the
~ button.
50 You may have to press it 2 or 3 times to pump water through the system.
51 Leave 4 seconds between shots, to let the steam build up.
C AFTER USE
52 Set the temperature control to •. Set the steam control to S.
53 Unplug the appliance.
54 Open the water inlet cover.
55 Hold it over a sink, turn it upside down, and drain the water from the reservoir, via the water
inlet.
56 Close the water inlet cover.
57 Sit the iron on its heel.