Spicer Single Drive Axles Service Manual: S110 and S130 - Manual (Page 30)

27
Wheel Differential Assembly
Wheel Differential
Assembl
y
6. Remove the half shafts first and then remove their
side pinions and thrust washers.
7. Remove the full shaft, side pinions and thrust wash-
ers.
8. Remove inner side gear and thrust washer.
9. Remove bearing cones from ring gear and differen-
tial case in two steps:
A. Mount puller vertically to split bearing. This action
will start moving the bearing off case and gear.
B. Mount puller horizontally to remove cone.
10. Press new bearing cone on the differential case.
Half
Differential
Shaft