Spicer Single Drive Axles Service Manual: S110 and S130 - Manual (Page 46)

43
Wheel Adjustment
Wheel End
Wheel Ends without Oil Fill Hole
1. With axle level and wheel ends assembled, add lubri-
cant through filler hole in carrier until fluid is level
with the bottom of filler hole.
2. Raise the right side of the axle six (6) inches (152
mm) or more. Hold axle in this position for one (1)
minute.
3. Lower the right side.
4. Raise the left side of the axle six (6) inches (152
mm) or more. Hold axle in this position for one (1)
minute.
5. Lower the left side.
6. With axle on a level surface, add lubricant through
carrier oil filler hole until fluid is level with the bot-
tom of the hole.
Note: Axles without wheel end fill holes will require approxi-
mately 2.5 additional pints of lubricant to bring the lube
level even with the bottom of fill hole.
1 - Oil will run into wheel end
2 - Oil will run into wheel end
1 2