Spicer Tandem Drive Axles Service Manual J340-S, J380-S, J400-S, W460-S - Manual (Page 17)

OUTPUT SHAFT DISASSEMBLY
1 . Remove rear drive shaft.
2 . Remove output shaft bearing cage assembly from forward
rear axle housing.
3 . Mount output shaft in vise by clamping yoke in jaws of
vise.
4 . Remove nut and yoke.
5 . Use snap ring tool to remove snap ring from bearing
retainer.
Flanged Hex Nut
(500-600 Lb-Ft)
(678-813 N-m)
End Yoke Assembly (Output)
Output Shaft Oil Seal
Output Shaft Bearing Cage
Bolt
(30-40 Lb-Ft)
(41-55 N-m)
Output Shaft
15
Snap Ring
Output Shaft Bearing
6 . Remove bearing and retainer from shaft.
7. Using a suitable sleeve to support bearing inner race,
press bearing from shaft.
8 . Using suitable sleeve, press seal from retainer.
9 . Clean and inspect all components. Replace all worn or
damaged components with genuine Spicer replacement
parts.
Output Shaft Disassembly Complete
IMPORTANT: Torque
specifications, shown on illustration,
apply only to J Model. See Page 33-
34 for W Model torque specifications.