Spicer Tandem Drive Axles Service Manual J340-S, J380-S, J400-S, W460-S - Manual (Page 26)

OUTPUT SHAFT ASSEMBLY
1 . Support output shaft bearing and press output shaft into
bearing.
2 . Install bearing cage over bearing and secure with snap
ring.
NOTE: To insure proper end play, both inner and outer
bearings are in matched sets with spacers. Do not mix
separate bearings.
CAUTION: Use only enough pressure to lightly seat
bearings against the thick spacer. Excessive pressure could
damage the assembly.
3 . Install new seal using seal installer tool (See Recom-
mended Service Tools, Pgs. 35-36).
4 . Install end yoke using yoke installer tool (See Recom-
mended Service Tools, Pgs. 35-36) and place washer
onto shaft. Clean and dry threads, then coat with Loctite
#680 and torque to 500-600 Lb-Ft (678-813 N-m).
5 . Clean mating surface on axle housing and output shaft
bearing retainer. Apply a 1/16” bead of Loctite #518
Gasket Eliminator on housing mounting flange and around
bolt holes. Install output shaft, with lube trough to
bottom. See Figure 17.
Tighten mounting bolts evenly to
30-40 Lb-Ft (41-55 N-m).
6 . Install rear drive shaft.
FFFFFigur igur igur igur igure 1 e 1 e 1 e 1 e 17 7 7 7 7
Loctite #518
Lube Trough
24
End Yoke Assembly (Output)
Output Shaft Oil Seal
Output Shaft Bearing Cage
Bolt
(30-40 Lb-Ft)
(41-55 N-m)
Output Shaft
Snap Ring
Output Shaft Bearing
Flanged Hex Nut
(500-600 Lb-Ft)
(678-813 N-m)
Output Shaft Assembly Complete