Spicer Wheel Ends Service Manual, Steer & Drive Wheel Ends - Manual (Page 30)

28
LMS Drive Removal
LMS Drive Axle - Removal
Never work under a vehicle supported by only a jack.
Always support vehicle with stands. Block the wheels and
make sure the vehicle will not roll before releasing the
brakes.
Wheel end seals can be easily damaged during handling.
Leave the seal in its package until installation to prevent
damage or contamination.
1. Jack up vehicle. Place drain pan under wheel end.
2. Remove stud nuts, lock washers and taper dowels (if
present), drive axle shaft and gasket.
3. Remove spindle nut and locking system.
4. If tires on, use a dolly and pull wheel end outward to
loosen outer bearing and hub.
5. Remove outer bearing.
6. Remove Spacer.
WARNING
IMPORTANT
Lock
washer
Axle shaft
Gasket
Hub
Outer jam nut
Spindle washer
Lock ring
Inner jam nut
Hub
Outer bearing
Hub
Hub
Spacer