Spicer Wheel Ends Service Manual, Steer & Drive Wheel Ends - Manual (Page 38)

36
LMS Steer Assembly
11. With a dial indicator, measure the wheel bearing
endplay to verify that it is not greater than .005".
12. Install the keeper ring into the milled slot of the nut
so that the flat of the ring lines up with the flat of the
spindle end.
Note: If keeper ring can not be engaged, rotate the spindle nut
in a clockwise / tighten direction only until it can be
engaged. Do not back the nut off.
Bottom Legs Point
Away From Nut