TELEFUNKEN TLF FP 500 - Handbuch (Seite 15)

PARTS AND FEATURES
- 14 -
1. Food Pusher
2. Food Chute Lid
3. Removable loop
4. Bowl Lid
5. Chopping Blade
6. Bowl
7. Disc Stem
8. Base
9. Control Knob
10.Juicer
11. measuring cup
12. Jar lid
13. Jar Assembly
14. Shred Disc
15. Slice Disc
CONTROL KNOB
1. Pulse
2. MIN
3. MAX
4. OFF
Pulse — turn the knob by anticlockwise to“PULSE” and held for unit to operate. When released, unit will stop. Use
PULSE for short processing tasks, such as chopping nuts, raw meats, or vegetables. This lets you check processed
results and control the tininess.
MIN —turn the knob deasil to“MIN”, the machine run at low speed continuously until the knob turns to “OFF”
MAX —turn the knob deasil to “MAX”, the machine run at high speed continuously until the knob turns to “OFF”
OFF —Processor should always be left in OFF position when unit is not in use.
USING YOUR FOOD PROCESSOR
Note: Do not attempt to chop ice in this food processor; it will damage container and dull the Chopping Blade. This
unit will not whip cream, beat egg whites to a desirable volume, grind coffee beams or spices with high oil content,
or slice or shred hard-cooked eggs, marshmallows, or soft cheeses.
Important: For your protection, This unit has an interlock system so the processor won’t operate unless the Bowl is
locked onto the Base and the Cover is correctly locked onto the bowl, be ensure the Food Chute Lid on the Bowl Lid
is also on the lock position. Do not attempt to operate the unit without the Bowl lid, Bowl and Food Chute
Lid being correctly in place. Be sure the Base is on a flat, dry and clean surface before you begin processing.
HOW TO ASSEMBLY THE BOWL
1. Place the unit base on a dry level surface.
2. Put down the Disc Stem until it is correctly placed on the Base, as shown in the Fig. 1.
3. Ensure the Bowl handle align with the mark unlock on the Base while aligning the centerlines of Bowl and Base,
put down the Bowl until it is correctly placed on the Base,snap the Bowl handle and rotate it anticlockwise until it is
fully locked on the Base, then the Bowl handle will align with the mark lock on the Base, as shown in the Fig. 2.
Note: There is only one position for the Bowl to be locked onto the Base. The unit won’t operate if the Bowl is not
correctly placed onto the Base.
HOW TO ASSEMBLY THE COVER
Line up the mark on the cover and the mark unlock on the Bowl while align the centerlines of the cover and the Bowl.
Put down the cover until it is correctly placed on the Bowl, twist the cover anticlockwise towards LOCK until it click
into the Bowl, then the mark on the cover will line up with the mark lock on the Bowl, cover is fully locked onto the
Bowl, as shown in the Fig.3.
Note: When cover is correctly placed, the safety mechanism on the cover and Bowl will be in same position. The
unit won’t operate if the cover is not correctly placed onto the Bowl .
HOW TO OPEN THE COVER
Twist the cover clockwise towards UNLOCK until the mark on the cover will line up with the mark unlo ck on the Bowl,
cover is fully unlocked from the Bowl, as shown in the Fig.4.
TECHNICAL DATA
Rated voltage: 230V~, 50Hz
Rated power: max 1100W
Class II appliance