VTech CS6529-4B Abridged manual - Manual (Page 6)

6
Set date and time
If you subscribe to caller ID service, the day, month and time are set automatically
with each incoming call. You can also set the date and time manually.
Press MENU when the handset is not in use.
Scroll to Set date/time and then press SELECT.
Use the dialing keys ( 0-9) to enter the month (MM), date (DD) and year (YY).
Then press SELECT.
Use the dialing keys ( 0-9) to enter the hour (HH) and minute (MM).
Then press or to choose AM or PM.
Press SELECT to save.
Telephone operation
Make a call
Press or and then dial the telephone number.
Answer a call
Press , or any dialing key.
End a call
Press OFF or put the handset to the telephone base or charger.
Speakerphone
During a call, press to switch between speakerphone
and normal handset use.
Volume
During a call, press VOLUME/ or VOLUME/ to adjust
the listening volume.
Mute
The mute function allows you to hear the other party but the other party cannot hear you.
During a call, press MUTE. The screen displays Muted.
Press MUTE again to resume the conversation. The screen displays
Microphone on briefly.
Call waiting
When you subscribe to call waiting service from your telephone service provider,
you hear an alert tone if there is an incoming call while you are already on a call.
Press FLASH to put the current call on hold and take the new call.
Press FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of that handset
without disconnecting the call. The next call rings normally at the preset volume.
Press OFF or MUTE, then displays and Ringer muted displays briefly.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to touch-tone
dialing temporarily during a call.
During a call, press TONE .
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end the call.
Find handset
Use this feature to find all system handsets.
To start paging:
Press FIND HANDSET on the telephone base. All idle
handsets ring and display ** Paging **.
To end paging:
Press FIND HANDSET on the telephone base.
Press , , OFF or any dialing key on a handset.
Place the handset in the telephone base or charger.
Do not press and hold FIND HANDSET for more than four seconds. It may lead to
handset deregistration.
Redial list
Each handset stores the last 0 telephone numbers dialed. When there are already
0 entries, the oldest entry is deleted to make room for the new entry.
To review and dial a number from the redial list:
Press REDIAL when the phone is not in use.
Press , or REDIAL repeatedly until the desired entry displays.
Press or to dial.
To delete a redial entry:
When the desired redial entry displays, press DELETE.
.
.
3.
4.
5.
•
•
•
•
•
.
.
•
•
•
.
.
3.
•
•
•
•
.
.
3.