Warrior 2380 SPARE TIRE LICENSE MOUNT - 3RD BRAKE LIGHT (Universal) - Manual

Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected] Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
2380 SPARE TIRE LICENSE MOUNT
w/3
rd
BRAKE LIGHT
INSTALLATION INSTRUCTIONS
IMPORTANT: The installation of this kit requires some alteration to your vehicles’ license plate
light and 3
rd brake wiring. If you are not comfortable with your abilities in this regard, please
seek out a qualified individual to handle that part of the installation for you.
1. Begin by removing your spare tire from the mount on the back of your vehicle and set it aside.
Check to see if there is an access hole in the center of the spare tire mount where the studs
are. The wiring for the license plate light will need to pass through here. If there is not a hole,
you will need to drill approximately a 1/2” hole directly in the center of the studs through the
spare mount. If the mount is constructed of steel, spray the hole with some suitable enamel
paint to inhibit rust.
2. Place the round lug plate onto the spare
mount studs. The plate is designed to fit
5x4.5” through 5x5.5” lug patterns.
Remove the center cap from your spare
tire (if equipped), reinstall the spare onto
the mount studs and tighten the lug nuts.
The round lug plate should now be
‘sandwiched’ between the spare tire
mount and the spare tire with the
adjustment tube pointing out through the
spare.