Warrior 2380 SPARE TIRE LICENSE MOUNT - 3RD BRAKE LIGHT (Universal) User Manual
Page 2
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY
•
INTEGRITY
•
INNOVATION
•
SERVICE
3. To install the license plate light, first insert
the wires through the right side middle hole
of the mounting tab on the lower portion of
the license plate holder. The two small
metal screws supplied screw in from the
back side of the tab and into the plastic of
the light housing. The wires will then be
inserted through the hole at the bottom of
the adjustment tube just behind the license
holder and fed out through the end of the
tube.
4. Next, install the rubber gasket for the 6” oblong LED brake light. Press the light into the
gasket firmly until it seats completely. We are only utilizing the green (+) and white (-) wires,
so the brown one can be trimmed short and taped off.
5. Attach your preferred style of plug(s) so that the connections take place within the adjustment
tube, but leave enough slack in the wires so that you can still pull the plug out for
disconnecting.
6. The wiring will vary dependent upon the vehicle, so some wire hunting with a tester may be
needed to help identify which wires you will be utilizing. Remove the OEM license plate holder
and light if your vehicle is equipped with them. Locate the OEM license plate light wiring and
disconnect the wires. Connect your longer wires to the end of the OEM license plate light
wiring and strategically run them along the inside edge of the body and out through the lug
plate adapter. You should be able to lay the wires along existing paths and out through the
tailgate to the spare tire mount.
7. Take your extended license light wires and
feed them into the hole in the backside of the
lug plate and out through the adjustment tube.
Leave just enough slack to attach a plug on
the end so there’s not too much wiring inside
the adjustment tubes once they’re sleeved
together.
8. For the 3
rd
brake light, you may either splice
into the existing factory 3
rd
brake light and
have two 3
rd
brake lights, or cut the wires and
feed them over and through the hole in the
backside of the lug plate adapter.