Warrior 888 JK RENEGADE RACK AIR DAM (Universal) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
888 JK RENEGADE RACK AIR DAM
INSTALLATION INSTRUCTIONS
07-UP JK WRANGLER
Please read through the entire instructions before beginning. The 888 Renegade Rack Air Dam may be utilized to cut
down on wind noise generated by the Renegade Roof Rack System. It is mainly a bolt on kit, but it will require some drilling
through the two front angled dimple plates of the Renegade Racks’ front basket section.
KIT CONTENTS:
Description Qty Qty
Air Dam 1 5/16” Lock Washer 4
5/16” x _” Hex Bolt 4 5/16” Hex Nut 4
5/16” Flat Washer 4
INSTALLATION:
1. Begin by placing the air dam face down on a smooth surface then take a tape measure and measure the center-to-
center, hole width spread of the air dam mounting tab brackets. This distance should measure approx. 29.250”
between the two mounting tabs and 2.250” between the two holes on the tabs themselves. Some slight variance in
the manufacturing process is acceptable, so if your width measurement is different write it down and use that for the
proceeding steps.
2. Remove the front basket section of the Renegade Rack System for ease of accessibly during these next steps.
Looking at the front basket section of the Renegade Rack you will see two dimple plates that span the two horizontal
bars of the basket. Measuring from the outside of one of the dimple plates (doesn’t matter which) measure inwards
5/8” (.625) and draw a 2.5” long vertical line with a pencil. Next, measure from that pencil line, the center-to-center
hole spread distance of the air dam mounting tabs and draw another vertical pencil line on the other dimple plate.
Visualize the center of dimple and draw a horizontal hash mark through the vertical pencil line on both dimple
plates. Measure 1-1/8
th (1.125”) both upwards and down from these hash marks giving a 2-1/4 (2.250”) vertical hole
spread. Mark these locations with a pencil then use a center punch to prepare for drilling.