Warrior 54005-54006 4DR DIY RENEGADE RAIL KIT (2007 – 2013 Jeep JK Wrangler) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
5. If you have purchased kit #54006, there will be dimpled step plates and
gussets. Refer to image below for proper placement of these components.
The angled sections that fit down between the Rubicon rail and the
Renegade bar may require some slight fitment grinding for a precise fit.
NOTE: Once satisfied with the steps positioning, set them aside and
fully weld around the stand-offs and only _ of the way around the bar
ends before finish welding the steps and gussets on. This _ weld is so the
gussets will lay completely flat against the bar and rail. Once the gussets
are tack-welded you can then fully weld the bar ends.
6.
Thoroughly clean all surfaces of any grease, oil or weld splatter then spray all bare metal with a protective
paint. For a much more durable finish, Warrior recommends you locate a local powdercoat or bedliner
company to finish coat the Renegade Rails before installation onto your Jeep.
If you need further assistance assembling your product, please contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS