Warrior 2960 Complete LED Tail Light Kit (2007 – 2013 Jeep JK Wrangler) - Manual (Page 2)

QUALITY • INTEGRITY • INNOVATION • SERVICE
7. Next, build your wiring harnesses. The easiest way to do this is the cut the light sockets off of the
harness that is attached to your OEM tail lights and wire the LED pigtails directly into this harness. This
results into a harness that you can disconnect from the Jeep and won’t require any modification to the
Jeep’s main wiring harness.
8. Remove both stock taillights and cut off the two bulbs as shown below. Strip back the 5 wires on the now
loose plug where the bulbs were cut off
9. Connect your LED light wires to this harness. Below are the wires to join
JK Harness 4” Tail Light Pigtail
Purple/White Black (Tail Marker)
Black White (Ground)
Yellow/White Red (Turn/Stop Marker)
JK Harness 2” Reverse Light Pigtail
Green/White Brown (Positive)
Black White (Ground)
10. Next, connect your load resistors. The load resistor will have two wires. Use the included blue splice
connectors to connect one end to the white ground wire on the LED Tail Light Pigtail, and the second wire
to the red turn/stop wire on the LED Tail Light Pigtail.