VEGA VEGALOG 571 EP (Ex) User Manual
Page 22
Advertising
Also note the following instructions:
l
The supply voltage directly on the sensor must be at least
9 V
l
During the parameter adjustment of the PA sensors series
40/50 via VEGACONNECT 3 or MINICOM, indicating and
adjustment module, the adjustment and the scaling in the
sensor itself should not be modified because this can
influence the measured value to be transmitted
l
plics
®
sensors are supported from EP firmware version
1.40
22
VEGALOG
571 EP (Ex) - Input card Profibus PA
Set up
25681
-EN
-070529
Advertising