VEGA VEGAVIB 67 - relay output - Manual (Page 10)

4 Mounting
4.1 General
In general, VEGAVIB 67 can be mounted in any position. The
instrument must be mounted in such a way that the vibrating
element is at the height of the requested switching point.
Use the recommended cables (see chapter "Connecting to
power supply") and tighten the cable gland.
You can give your VEGAVIB 67 additional protection against
moisture penetration by leading the connection cable down-
ward in front of the cable entry. Rain and condensation water
can thus drain off. This applies mainly to mounting outdoors, in
areas where moisture is expected (e.g. by cleaning processes)
or on cooled or heated vessels.
Fig. 2: Measures against moisture penetration
Do not hold VEGAVIB 67 on the vibrating element. Especially
with flange and tube versions, the sensor can be damaged by
the weight of the instrument.
Remove the protective cover just before mounting.
The process fitting must be sealed if there is gauge or low
pressure in the vessel. Before use, check if the seal material is
resistant against the measured product and the process
temperature.
The max. permissible pressure is stated in the "Technical
data" in the "Supplement" or on the type label of the sensor.
The vibrating level switch is a measuring instrument and must
be treated accordingly. Bending the vibrating element will
destroy the instrument.
Switching point
Moisture
Transport
Pressure/Vacuum
Handling
10 VEGAVIB 67 - with relay output
Mounting
29295
-EN
-060508