VEGA VEGAVIB 55 - contactless electronic switch - Manual (Page 19)

6 Setup
6.1 In general
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
DIL switch for mode adjustment - min./max. (1)
l
Signal lamp (4)
Note:
As a rule, always set the mode with the mode switch (1) before
starting setup VEGAVIB 55 . The switching output will change
if you set the mode switch (1) afterwards. This could possibly
trigger other connected instruments or devices.
6.2 Adjustment elements
2
3
4
1
Fig. 10: Oscillator - Contactless electronic switch
1 DIL switch for mode adjustment
2 Ground terminal
3 Screwed terminals
4 Control lamp
With the mode adjustment (min./max.) you can change the
switching condition of the output. You can set the required
mode according to the "Function chart" (max. - max. detection
Function/Configuration
Mode adjustment (1)
VEGAVIB 55 - - contactless electronic switch 19
Setup
29302
-EN
-070109