VEGA VEGAVIB 63 - Relay (DPDT) - Manual (Page 16)

5 Lift the opening levers of the terminals with a screwdriver (see
following illustration)
Fig. 7: Connection steps 5 and 6
6 Insert the wire ends into the open terminals according to the wiring
plan
7 Press down the opening levers of the terminals, you will hear the
terminal spring closing
8 Check the hold of the wires in the terminals by lightly pulling on
them
9 Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 If necessary, carry out a fresh adjustment
11 Screw the housing cover back on
The electrical connection is finished.
5 .3 Wiring plan, single chamber housing
The following illustrations apply to the non-Ex as well as to the EEx-d
version.
16 VEGAVIB 63 • - Relay (DPDT)
5 Connecting to power supply
29277
-EN
-120418