VEGA VEGACAP 63 - Relay (DPDT) - Manual (Page 29)

29
9 Supplement
VEGACAP 63 • - Relay (DPDT)
30008-EN-130916
Switching voltage
Ʋ Min. 10 mV
Ʋ Max. 253 V AC, 253 V DC
With circuits > 150 V AC/DC, the relay contacts must be
in the same circuit.
Switching current
Ʋ Min. 10 µA
Ʋ Max. 3 A AC, 1 A DC
Breaking capacity
Ʋ Min. 50 mW
Ʋ Max. 750 VA AC, 54 W DC
If inductive loads or stronger currents are switched
through, the gold plating on the relay contact surface will
be permanently damaged. The contact is then no longer
suitable for switching low-level signal circuits.
Contact material (relay contacts) AgNi (Au plated) or AgSnO (Au plated)
Modes (switchable) Min./Max.
Switching delay
Ʋ When immersed 0.7 s
Ʋ When laid bare 0.7 s
Ʋ In case of failure 1 s
Ambient conditions
Ambient temperature on the housing
-40 … +80 °C (-40 … +176 °F)
Storage and transport temperature -40 … +80 °C (-40 … +176 °F)
Process conditions
Process pressure
Ʋ Threaded versions -1 … 64 bar/-100 … 6400 kPa (-14.5 … 928 psig), de-
pending on the process fitting
Ʋ Flange version -1 … 64 bar/-100 … 6400 kPa (-14.5 … 928 psig), de-
pending on the process fitting
Ʋ Flange version ≥ 3"/DN 80, plated -0.4 … 64 bar/-40 … 6400 kPa (-5.8 … 928 psig), de-
pending on the process fitting
Process temperature VEGACAP 63 of 316L
Ʋ Insulation PE -40 … +80 °C (-40 … +176 °F)
Ʋ Insulation PTFE -50 … +150 °C (-58 … +302 °F)
Process temperature (thread or flange
temperature) with temperature adapter
(option with PTFE)
-50 … +200 °C (-58 … +392 °F)