VEGA VEGAPULS 65 (≥ 2.0.0 - ≤ 3.8) Profibus PA - Manual (Page 56)

Status
code Description according to Pro-
fibus standard Possible cause
0 x 0C bad - sensor failure l Hardware error
l Converter error
l Leakage pulse error
l Trigger error
0 x 10 bad - sensor failure l Measured value generation error
l Temperature measurement error
0 x 1f bad - out of service constant " Out of Service" mode switched on
0 x 44 uncertain - last unstable value Failsafe replacement value (Failsafe-Mode = "Last value" and
already valid measured value since switching on)
0 x 48 uncertain substitute set l Switch on simulation
l Failsafe replacement value (Failsafe-Mode = "Fsafe value")
0 x 4c uncertain - initial value Failsafe replacement value (Failsafe-Mode = "Last valid value" and
no valid measured value since switching on)
0 x 51 uncertain - sensor; conversion
not accurate - low limited Sensor value < lower limit
0 x 52 uncertain - sensor; conversion
not accurate - high limited Sensor value > upper limit
0 x 80 good (non-cascade) - OK OK
0 x 84 good (non-cascade) - active
block alarm Static revision (FB, TB) changed (10 sec. active, after the parameter
of the static category was written)
0 x 89 good (non-cascade) - active ad-
visory alarm - low limited Lo-Alarm
0 x 8a good (non-cascade) - active ad-
visory alarm - high limited Hi-Alarm
0 x 8d good (non-cascade) - active crit-
ical alarm - low limited Lo-Lo-Alarm
0 x 8e good (non-cascade) - active crit-
ical alarm - high limited Hi-Hi-Alarm
56 VEGAPULS 65 • Profibus PA
10 Supplement
28447
-EN
-090305