VEGA VEGAKON 66 with relay output - Manual (Page 20)

7 M aintenance and fault rectification
7 .1 Maintenance
When used as directed in normal operation, VEGAKON 66 is
completely maintenance free.
7 .2 Electronics exchange
In general, all oscillators of series KONE66 can be inter-
changed. If you want to use an oscillator with a different signal
output, you can download the corresponding operating
instructions manual from our homepage under Downloads.
Proceed as follows:
1 Switch off power supply
2 Unscrew the housing cover
3 Loosen compression fittings with a Phillips screwdriver
4 Pull the connection cables out of the terminals
5 Loosen the two holding screws with a screw driver
(Phillips)
6 Lift tensile proving ring and pull out the old electronics
module
7 Compare the new oscillator with the old one. The type label
of the oscillator must correspond to that of the old
oscillator.
8 Note settings of all adjustment elements of the old
electronics module.
Set the adjustment elements of the new electronics module
to the same settings of the old one.
9 Screw in and tighten the two holding screws with a
screwdriver (Phillips)
10 Insert the wire ends into the open terminals according to
the wiring plan
11 Tighten the screw terminals
12 Check the hold of the wires in the terminals by lightly
pulling on them
13 Check the tightness of the cable entry. The seal ring must
completely encircle the cable.
14 Screw the housing cover back on
The electronics exchange is now finished.
20 VEGAKON 66 - with relay output
Maintenance and fault rectification
32649
-EN
-070615