VEGA VEGAWAVE 62 - Relay (DPDT) - Manual (Page 18)

6 Set up
6 .1 General information
The figures in brackets refer to the following illustrations.
On the electronics module you will find the following indicating and
adjustment elements:
l Potentiometer for adaptation to the product density (1)
l DIL switch for mode adjustment - min./max. (2)
l Signal lamp (5)
Note:
As a rule, always set the mode with mode switch (2) before starting the
setup of VEGAWAVE 62. The switching output will change if you set
the mode switch (2) afterwards. This could possibly trigger other
connected instruments or devices.
6 .2 Adjustment elements
3
4
5
1
2
Fig. 11: Electronics and connection compartment - relay output
1 Potentiometer for switching point adaptation
2 DIL switch for mode adjustment
3 Ground terminal
4 Connection terminals
5 Control lamp
With the potentiometer you can adapt the switching point to the solid. It
is already preset and must only be modified in special cases.
Function/Configuration
Electronics and connec-
tion compartment
Switching point adapta-
tion (1)
18 VEGAWAVE 62 • - Relay (DPDT)
6 Set up
32252
-EN
-120418