VEGA PLICSRADIO R61 Wireless receiving unit - Manual (Page 22)

22
6 Setup with the integrated display and adjustment unit
PLICSRADIO R61 • Wireless receiving unit (single channel)
32625-EN-130228
After being switched on, PLICSRADIO R61 first of all carries out a
short self-check. The following steps are carried out:
•
Internal check of the electronics
•
indication of the instrument type, firmware version as well as the
instrument TAG (instrument name)
•
The output signal jumps briefly to the set fault value
•
Establishment of a radio connection
Then the actual measured value is indicated and outputted.
The measured value indication displays the digital indication value,
the measurement loop designation (measurement loop TAG) and the
unit. The actual signal strength can be also displayed. By pushing the
[>] key, you move between the individual indicating windows.
1. By pushing [OK] you move from the measured value indication to
the main menu.
2. Select the menu item "Device settings" with [->] and confirm with
[OK].
You can assign an unambiguous name to PLICSRADIO R61 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
→
Enter the requested values via the appropriate keys and save
your settings with [OK].
The emitting and receiving units must be always set to the same radio
channel. When using several independent radio links, each radio link
must be provided with a different channel. In total, seven radio links
are available (channel 0 … 6).
→
Enter the values via the appropriate keys and save your settings
with [OK].
Switch-on phase
Measured value indica-
tion/Main menu
Device settings - Device-
TAG
Device settings - Radio
channel