VEGA VEGABAR S 14 - Manual (Page 18)

1
2
3
Fig. 11: Loosen the plug insert
1 Cable gland
2 Plug insert
3 Plug housing
4 Remove approx. 5 cm of the cable mantle, strip
approx. 1 cm insulation from the individual
wires
5 Lead the cable through the cable gland into the
plug housing
6 Connect the wire ends to the screw terminals
according to the wiring plan
2
3
1
4
Fig. 12: Connection to the screw terminals
1 Cable gland
2 Plug housing
3 Plug insert
4 Plug seal
7 Snap the plug insert into the plug housing and
insert the sensor seal
8 Plug the plug insert with seal to VEGABAR S
14
and tighten the screw
The electrical connection is finished.
Connection via angle plug connector with
hinged cover
Proceed as follows:
1 Loosen the screw in the cover of the plug
connector
2 Open the cover and remove it
3 Press the plug insert downwards
4 Loosen the screws of the strain relief and cable
entry
4
3 2 1
3
2
1
Fig. 13: Loosen the plug insert
1 Plug insert
2 Strain relief
3 Cable gland
4 Plug housing
5 Remove approx. 5 cm of the cable mantle, strip
approx. 1 cm insulation from the individual
wires
6 Lead the cable through the cable gland into the
plug housing
7 Connect the wire ends to the screw terminals
according to the wiring plan
1
5
2
3
4
Fig. 14: Connection to the screw terminals
1 Cable gland
2 Cover
3 Plug housing
4 Plug insert
5 Plug seal
8 Snap the plug insert into the plug housing and
insert the sensor seal
18 VEGABAR S 14
Connecting to power supply
32950
-01
-101123