3 wiring plan, 5 set up, 1 setup steps – VEGA VEGABAR S 14 User Manual
Page 19: 5 s et up
Information:
Note the correct arrangement, see illustra-
tion
9
Tighten the screws on the strain relief and
cable entry
10 H
ook in the cover and push onto the plug
connection, tighten cover screw
11 P
lug the plug insert with seal to VEGABAR S
14
and tighten the screw
The electrical connection is finished.
4
.3
Wiring plan
Angled plug connector according to ISO 4400
1
2
3
+
-
1
Fig. 15: Version: Electrical connection "Y", view to the connection on
the instrument side
1
Voltage supply and signal output
Round plug connector M12 x 1
3
+
-
1
3
2
4
1
Fig. 16: Version: Electrical connection "M", view to the connection on
the instrument side
1
Voltage supply and signal output
5 S
et up
5
.1
Setup steps
After mounting and electrical connection, VEGA-
BAR S 14 is ready for operation.
VEGABAR S 14 delivers a current of 4 … 20 mA
corresponding to the actual process pressure.
Further settings are not necessary.
VEGABAR S 14
19
Set up
32950
-
01
-
101123