VEGA VEGACONNECT 4 - Manual (Page 11)

1 3
2
OPEN
TWIST
USB
LOCK
Fig. 3: Connection possibilities
Communication via I²C protocol
l Use of VEGACONNECT 4 in all plics
®
sensors through direct
installation (see connection examples)
l For connection to the I²C (Com.) interface of all plics
®
sensors,
connection 1
l For connection to the I²C interface instead of the adjustment
module MINICOM (VEGAPULS 40, 50, VEGAFLEX 50, VEGA-
SON
50 series), connection 2
Communication via HART protocol
l For connection to the 4 … 20 mA cable (an additional HART
resistor will be required depending on voltage supply/processing),
connection 3
In hazardous Ex areas, the HART or I²C cable of VEGACONNECT 4
can be connected to an Ex approved sensor. VEGACONNECT 4 and
the PC must not be located in Ex area.
VEGACONNECT 4 can be connected to the I²C bus interface of the
following sensors.
l all sensors of plics
®
series
l VEGAPULS series 40, 50 from software version 4.00.00
l VEGASON series 50 from software version 4.00.00
l VEGAFLEX series 50 from software version 4.00.00
l VEGACAP from software version 1.10
l EL/EK (PA) with electronics module CAPE34
l VEGADIS 50/61
Connection via I²C bus
VEGACONNECT 4 with connection box • Interface converter USB - HART/I²C 11
4 Connection
32628
-
EN
-091118