VEGA VEGAWAVE 62 - two-wire - Manual (Page 19)

6 Set up
6 .1 General information
The figures in brackets refer to the following illustrations.
On the electronics module you will find the following indicating and
adjustment elements:
l Potentiometer for adaptation to the product density (1)
l DIL switch for mode adjustment - min./max. (2)
l Signal lamp (5)
Note:
As a rule, always set the mode with mode switch (2) before starting the
setup of VEGAWAVE 62 . If the instrument is used in conjunction with
a signal conditioning instrument, always set the mode switch (2) on
VEGAWAVE
62 to max. mode.
The mode is selected on the signal conditioning instrument with the
mode switch.
The switching output will change if you set one of the two mode
switches afterwards. This could possibly trigger other connected
instruments or devices.
Function/Configuration
VEGAWAVE 62 • - two-wire 19
6 Set up
32255
-
EN
-120418