VEGA VEGACAP 63 Screening tube adapter Rod ø 16 mm - Manual (Page 3)

3
2 Mounting
Screening tube adapter • for VEGACAL 63, 64/VEGACAP 63
34849-EN-130916
2 Mounting
2.1 Version: screening against condensation
1
2
3
4
Fig. 1: Mounting of the screening tube adapter - screening against condensation
1 Probe
2 Process seal
3 Screening tube adapter
4 Centering cone (PTFE)
Caution:
Check the insulation of the probe for deep scratches.
To ensure the seal effect of the screening tube adapter, the isolation
of the probe must be undamaged in the area of the lower screening
tube adapter end.
1. Place the process seal (2) on the thread of the probe
2. If it is harmless to the process, grease the two O-rings with an
acid-free grease so that the rod of the probe slides more easily
3. Push the rod of the probe (1) through the screening tube adapter
(3)