VEGA Protective cover - Manual (Page 6)

3 Mounting
3
.
1 Mounting preparations
No tools are required for mounting.
3
.
2 Mounting steps
Proceed as follows:
1 Open the snap connection by pressing on the smooth housing half
2 1
Fig. 3: Loosen the snap-on connection by pushing and pulling
1 Version for single chamber housing
2 Version for double chamber housing
2 Opening the protective cover
2 1
Fig. 4: Opening the protective cover
1 Version for single chamber housing
2 Version for double chamber housing
3 In case of sensor housing with integrated indicating and adjust-
ment module, remove the foam rubber disc
4 Slide the protective cover over the sensor housing
Tools
6 Protective cover
3 Mounting
34296
-EN
-120516