2 mounting, 2mounting – VEGA KV 31 Mounting brackets For tubes with ø 50…200 mm (Vertical sensor mounting) User Manual
Page 5
2
Mounting
Take note of the operating instructions of the corresponding sensor
MINITRAC and the source holder VEGASOURCE.
Take note of the following mounting instructions:
l
Mount the bracket first, then the sensor and the source holder
l
The arrow cutout in the clamp (source container side) and the
transport lug of the source container must point in the same
direction (A) after mounting
l
Make sure that the two clamps (5 and 8) of the bracket are in
parallel. Do this by measuring the distances between the clamps
l
To avoid injuries, shorten the threaded rods (1) of the brackets to a
suitable length after mounting
Mount the bracket according to the following assembly drawing:
Operating instructions
Mounting brackets for
vertical mounting
Vertical sensor mount-
ing
Mounting brackets KV 31 • Source holder SE
5
2 Mounting
38482
-
EN
-120228