VEGA PM-BATT - Manual (Page 4)

2 Possible dangers and their causes
The battery pack consists of individual hermetically sealed containers
which are designed to withstand normal temperatures and pressures
when used correctly. Under these conditions there is neither a fire/
explosion hazard nor a danger of leaking contents. Incorrect handling
can cause overheating, ignition, deflagration or explosion. Should this
happen, toxic gases can be released and persons injured through acid
burns and poisoning.
The following factors could cause fire and explosion damages:
l
Mechanical damage
l
Short-circuit/wrong polarity on the connection cables leading to the
outside
l
Excessive current drain due to incorrect use
l
Too high temperatures (see technical data)
l
Contact of the battery contents with water
l
Charging of the power pack (not possible, because primary
battery)
Danger:
In the case of strong mechanical impact or a high-impact event to the
test system or the accumulator pack (e.g. drop from heights/accident)
the safety of the pack is no longer guaranteed. The accumulator pack
may look fine but there can be a perforation or damaged wire.
To avoid fire damage through self-ignition due to mechanical effects or
impact, the battery pack must be monitored for at least one hour at a
fireproof, well ventilated place. To avoid the risk of non-detected
damage to the battery pack, we recommend disposing of the battery
pack according to the valid regulations.
4 PM-BATT • Lithium metal power pack for PLICSMOBILE T61
2 Possible dangers and their causes
41931
-EN
-120416