VEGA KV 31 Mounting brackets For tubes with ø 50…100 mm - Manual (Page 5)

2 Mounting
Take note of the operating instructions of the corresponding sensor
MINITRAC and the source holder VEGASOURCE.
Take note of the following mounting instructions:
l
Mount the bracket first, then the sensor and the source holder
l
The marking arrow on the console (source holder side) and the
transport lug of the source holder must point in the same direction
after mounting.
l
Make sure that the two clamps (5 and 8) of the bracket are in
parallel. Do this by measuring the lateral distances between the
clamps
l
To avoid injuries, shorten the threaded rods of the brackets to the
suitable length after mounting
This half of the mounting bracket is already premounted when being
shipped.
When retrofitting a collimator etc., mount the sensor side of the
mounting bracket according to the following assembly drawing.
To facilitate mounting, mount the bracket first, then the sensor and the
source holder.
Operating instructions
Mounting bracket for 30°
inclined irradiation
Mounting - Mounting
bracket, sensor side
Mounting brackets KV 31 • Source holder SE 5
2 Mounting
41863
-
EN
-120228