VEGA KV 31 Mounting brackets For tubes with ø 50…100 mm - Manual (Page 8)

The marking arrows on the console and the collimator must point in the
same direction. After mounting, the transport lug of the source holder
must point in the same direction.
1
2
Fig. 4: The marking arrows of the console and the collimator point in the same
direction.
1 Collimator - Source holder side (VEGASOURCE)
2 Console - Source holder side (VEGASOURCE)
Note:
Adjust both sides of the mounting bracket to the respective tube
diameter before mounting the mounting bracket to the tube. This
facilitates the adjustment.
A later adjustment is difficult due to the weight of the mounting bracket.
1 Loosen the four screw connections until the console can be
shifted.
2 Adjust the consoles on the sensor side and the source holder side
according to your tube diameter.
Take note of the marking lines on the bracket. The edge of the
console must be exactly on the corresponding marking line.
Note marking arrows
Adjust mount-
ing bracket
8 Mounting brackets KV 31 • Source holder SE
2 Mounting
41863
-EN
-120228